Required Material

6 pieces of cardboard 5" long, 1" wide at the top and 1 3/4" wide at the bottom;

6 pieces of material 7" by 3 1/2", 1 piece of cardboard 3" by l 1/2", 1 piece of cardboard 1" by 2", 1 piece of material 5" by 21/2", 1 piece of material 2" by 3", needles and thread as for previous articles, and 5 spools of thread of various numbers to put in the holder. To make the spool holder, cut six pieces of material 7" by 3 1/2", and cover the six cardboards by following the directions given for the needle book. The middle piece has an additional pocket on the top to hold the scissors. This is covered on the piece of cardboard 3" long 1" wide at the bottom and 1 3/4" wide at the top. The top is cut to a point.

Pin each top piece to the bottom one and then join the three pieces together with an overhand stitch, a cross-stitch, or any other fancy stitch.

Cover a piece of cardboard 1" wide by 2" long with the same material and fasten it to the upper corner.

A number of spools of cotton and silk thread are laced to the holder. The spaces between the lacing on the top cover may be used as holders for the glove darner, stiletto, bodkin, pencil, etc. (See Fig. 1 B, Fig. 2 IV, V.)