New subjects: Bits; auger, center. Spokeshave. Chisel used for paring. Compasses. Wood: Same as in Fig. 1. Preparatory: Same as in Fig. 1.

Exercises.

1, 2, 3, 4. Same as in Fig. 1.

5. With compasses, mark round end on face side.

6.   Bore 1/4" hole at center of round end.. Use auger or center bit. To do this without splitting the piece, place it in the vise, face side up, and slightly compressed at right angles with the grain. Do not bore entirely through from face side, as the pit is apt to tear the wood badly when it comes through the back; turn piece over when the center is definitely marked on the back and bore from that side.

7.   Plane sides.

8.   Do not use sandpaper.

9.   Inspect for defects and remedy them.

Fig2