After you have traced the outline of the design with the chisels hold the plate over an alcohol or a Bunsen flame and when it is hot enough you can take it off of the cement.

Then cement it to the block again, but this time put the other side down. Now use your boxwood or steel punches and hammer the copper, or other metal, into bold relief or you can matt the ground with any one of the numerous punches shown at B.

Fig. 36. A Repousse Candlestick

Bossing the Work 108

A The Design On The Metal

Bossing the Work 109

B The Ring For The Candle

Bossing the Work 110

C The Candle Stick When Done