This is a good piece of work to start with because it is formed chiefly of straight lines. Draw a plan of it as shown in Fig. 31, full size and then measure the frame and the inside strips - you will observe that there are two of the latter - and find out exactly how long each strip should be.

Now measure and cut off three strips of iron and allow an extra inch for lapping the long strip that forms the frame. This done mark off the points where the strips are to be bent and use your flat nose pliers to bend the sharp corners and your round nose pliers to bend the curved parts of the frame.

Lap the ends of the strip forming the frame on the side 1/2 an inch, fasten the joint by putting a binder on it with your pliers and a light tap with your hammer will tighten it up.

Now if you will look again at Fig. 31, you will see that one end of the right inside strip projects up and beyond the rest of it and this end sets in the handle of the frame and strengthens it; put a binder on each place where it is shown in the drawing including the handle. Fix in the left inside bent strip with binders and put the binders on so that the rough ends will be inside, file down the rough places, rub the toaster all over with a piece of fine emery cloth until it is nice and smooth, rub it with some sweet oil, polish it off with a soft cloth and then present it to Pietro or Hilda or Wo Nang Fong or whoever it is that presides over the kitchen.

Fig. 31. A Useful Bent Iron Toaster