The sketch of a baby's swing here given is almost self-explanatory. The seat of the given is made from beech, say 1 in. thick and I5in. by 15in., with a hole? in. through each corner. Four ropes arc passed through these holes, and stopped by knots underneath. The other her ends are spliced or tie i, two to each upper rope. Eight wooden spindles, bored from end to end with 3/8-in. holes to allow the lower ropes to slide through, are passed on as shown. Eight crossbars, bored near the ends with 3/8-in. hides, and strung on - four between the two sets of spindles and four above them - will complete the suing. The cross-bars and spindles must be of beech, oak, or other hard wood,or they will be apt to split and lead to accident. The crossbars can he 2in. by 3/4 in. by loin., and the spindles lin. diameter and 3in. long. If the seat-guard is not considered deep enough, add four more spindles and four more cross-bars. Knots can be made above the seat-guard to keep the cross-pieces and spindles in place, if desired; but that is not usual, as the child's weight prevents slipping.

The four lower ropes should join the two upper ones about 12 in. above the top of the seat-guard. Two places are found in the ceiling so that when hooks are screwed in they will enter the wood of the joists, and not merely hold by the plaster or the lathing. By driving a knitting needle into the ceiling, the position of the joists can be found without much damage. The ropes must be hung by metal eyelets held in spliced loops.

Making and Hanging a Baby's Swing.

Making and Hanging a Baby's Swing.