Arthur H. Bell

The resistance coil mentioned in connection with the "wireless" telegraph receiver in the August number of this magazine, is not a single coil, but rather a set of coils of very fine resistance wire, wound non-induc-tively to prevent inductance when the current is passing through them. The construction of such a resistance suitable for distances of not over 25 miles transmission work is quite simple and can be made at small expense.

A wooden box is made, the top and bottom of which is 5x7 in. and 1/4 in. thick. Sides are made of 3 16 in. stock 2 in. wide, and of lengths to give the top and bottom a lap of about 1/4 in. all around. The bottom is nailed on, and the top attached with round head brass screws after being fitted with the attachments to be described:

Resistance For Wireless Receiver 263

With dividers lay off a half circle the radius of which is 2| in. and the center 1 3/8 in. from one side of the box. Bisect this arc and lay off five points 3/4 in. apart on either side, making 11 in all. Bore holes at these points of a size to receive with a tight fit the threaded part of some thumb screws with flat heads. At the center bore a hole for a brass machine screw with two nuts, which is to hold the arm made of a strip of spring brass 3 1/2 in. long and 1/2 in. wide.

This arm or lever has a hole at the center end to fit the machine screw with a loose fit, but without play, so that it will turn without binding. Fit a hard rubber knob at the outer end, 1/2 in. in from the line of the arc. The center screw is placed in the hole at the inner end; one of the nuts is then threaded on till it almost touches the arm, the screw is then put through the hole in the top and the other nut put on and screwed tight, thus holding all firmly, but allowing free movement of the arm.

The coils are then wound of insulated resistance wire to give a resistance of two ohms to each coil. In purchasing the wire, which should be at least as fine as No. 36 gauge, and No. 40 would better, inquiry should be made to learn the resistance of the wire per foot. It is then cut into lengths to give 2 ohms per length. Taking a piece of wire, fold it at the center and then wind it double over a round rod of about the size of a lead pencil, winding it carefully to avoid breakage. The coils, when wound in this way, have little or no inductance, as the current through one-half of the coil neutralizes that through the other half. When the coils have been wound remove the insulations at the ends and solder to the ends of the thumb screws projecting from the under side of the top, one end to one screw and the other end to the next adjoining. The first coil would connect the first and second screws, etc. In sel-dering it will be well to first deposit on the ends of each of the screws a small bead of soft solder, and then with a blow pipe, heat it up to the melting point, and when just soft enough put the end of the solder, immediately removing the flame.

Two double binding posts are then mounted, one in each corner of the top in line with the ends of the arc. To the left post connect the first thumb screw, and to-the right one connect the screw upon which the arm-turns. Use covered magnet wire for these connections and solder all of them. The top is then ready for attaching to the box. Double binding posts are necessary, as the local battery wires and wires from aerial and telephone receivers are connected thereto.

The telephone receiver for use with the wave detector, previously described, should be that known as the double head receiver, and should be of very high resistance, 1500 ohms being desirable if one cares to goto the expense of having one as high as that made up. The object of using a double head receiver is to exclude outside sound, so that for one ear may be a dummy, padded to make it sound proof.