This section is from the book "Plants And Their Uses - An Introduction To Botany", by Frederick Leroy Sargent. Also available from Amazon: Plants And Their Uses; An Introduction To Botany.
A piece of wood consists essentially of a mass of extremely slender fibers or fibrils, each comparable to a fibril of cotton, but firmly cemented together. The valuable qualities of woods, and their defects as well, depend in great measure upon the character and arrangement of these fibrils and of similar parts associated with them. Therefore some knowledge of the structure of wood helps us to understand its properties and to tell one kind of wood from another; and thus should lead us to a more intelligent, economical use of the material. The fibrous nature of wood is clearly shown by its splintery fracture when broken across the grain and by its separation into more or less delicate strands when crushed. Those who have had experience in chopping wood know that the ax cleaves as a rule most easily when cutting toward the center of the log; less easily in any other lengthwise direction, and least easily when directed slantingly or directly across the grain. This shows that the structural parts have a peculiarly definite arrangement. Something of this appears when we examine, for example, with a strong magnifier, the surface of a piece of pine wood, cut radially, i. e., toward the center of the log. We see, as shown in Fig. 229, that the wood is made up mainly of very slender, thin-walled tubes each closed and tapering at the ends; and besides these are numerous flat bundles of much smaller tubes running at right angles to the others and radially. These bundles of finer structure are called pith-rays because they are somewhat similar in texture to a cylinder of pith in the center of the log, and some of them at least, are extensions of it. Their relative softness makes the wood most easily separated along the planes in which they lie. Even to the naked eye their peculiar sheen makes the pith-rays apparent on a radial surface, and gives an especially attractive prominence to them in what the dealers call "quarter-sawed" timber. It is plain also that the fibrils, by which name we shall understand the closed longitudinal tubes that form the main part of wood, cannot be all just alike for they occur in alternating layers of darker and lighter color. Examination of these layers under the magnifier shows that in the lighter colored layer the tubes are of decidedly larger bore than those forming the darker layer. The pale layers of less compact material are called spring wood, and the more compact layers, summer wood, for reasons that will presently appear. On a tangential surface, that is to say, one cut with the grain but not toward the center of the log, these contrasted layers appear as broader bands often in beautiful systems of curves. On such a surface the cut ends of the pith-rays are to be seen under the magnifier (Fig. 230) as small, very narrow spots or streaks. If now we examine a crosscut or transverse section (i. e., a thin slice made at right angles to the direction of the fibrils) the magnifier will show us something more of the form and arrangement of the parts. As shown in Fig. 231 we can look through the central cavities of the tubular fibrils, and so get a better idea of their sizes and shapes and the thinness of the walls. They are seen to be arranged in radial rows, between which the pith rays often appear as more or less delicate lines of dense material. Here and there among the fibrils we see circular holes many times larger than the fibril-cavities. These are long, tubular reservoirs called resin-ducts from the material they contain which oozes out at a wound. On longitudinal surfaces they appear as more or less conspicuous yellowish or brownish streaks.

Fig. 229.-Radial section of white pine wood. Magnified about 50 diameters. (Original.)

Fig. 230.-Tangential section of white pine wood, 50/1. (Original.)

Fig. 231.-Transverse section of white pine wood, 50/1. (Original.)
In many woods there are no resin-ducts present, but there are numerous, commonly empty, canals sometimes considerably larger than resin-ducts and sometimes much smaller in diameter. They form a continuous system of tubes throughout the wood. Their appearance, viewed endwise, is shown for various woods in Figs. 235-241. They are known as pores or vessels, and in the sap-wood serve as pipes or reservoirs for conveying upward the crude sap absorbed by the roots or for storing it, together with more or less air, temporarily till needed. They thus share with the wood-fibrils the office of conduction which is performed alone by the fibrils of such woods as pine.
Figure 232 shows in a somewhat diagrammatic way the relative position of the various structural elements found in pine wood, with reference to one another and to the pith-cylinder within and the bark without. Between the bark and the wood is found a thin layer of soft, living material called the cambium (c) which is of vital importance because from it, after the first year, all the wood and bark is formed. At the beginning of each season's growth the cambium works vigorously and forms numerous full-size wood-fibrils, but as more and more new wood is added to the old, an increasing pressure results unless the bark yields readily to the strain. In many cases the bark holds firmly and this pressure is partly accountable for the fact that summer wood is commonly more compact than spring wood, which as we have seen results from the progressive flattening of the fibrils in the radial direction. Through the winter the outer bark becomes sufficiently cracked by the action of the weather to relieve the pressure upon the parts within; consequently at the return of spring the cambium can resume its work of wood-building under the most favorable conditions. As a result of these alternating changes of conditions, which in our climate are connected with the annual changes of temperature, we have in the wood what are known as annual rings or layers. In warm regions where comparatively uniform conditions prevail throughout the year, many trees grow continuously and the wood shows no annual layers at all. Sometimes peculiar conditions affecting growth give rise to layers intermediate between the annual ones, and these subdivisions of the annual layers may pass entirely around the circumference or they may be only partial. They are deceptive, but to the practiced eye their true nature is usually apparent and wherever well-pronounced layers are present it is generally safe to regard such rings as marking a year of growth.
 
Continue to: