This section is from the book "Hints And Practical Information For Cabinet-Makers, Upholsterers, And Furniture Men Generally", by John Phin. Also available from Amazon: Hints And Practical Information For Cabinet-Makers, Upholsterers, And Furniture Men.
For the ground color, stain your white lead to a light lead-color, with lampblack and a little rose-pink. Throw on black spots, with a graniting machine, a pale red, and fill up with white before the ground is dry.
A black ground when half dry, throw in vermilion, a deep yellow and white spots.
For the ground color, take white lead and thin it with turpentine, and slightly stain it with equal quantities of Prussian blue and lampblack. For the graining color, grind in beer a mixture of Prussian blue and raw sienna; when the ground is dry, spread a transparent coat of the graining color on the surface of the work, and soften; then with the cork mottle by rubbing it to and fro across the work, to form the fine long grain or mottle. When this is done, soften and top grain in wavy but perpendicular directions; varnish when dry.
The best and cheapest and most convenient simple material, for making grounds for light oak, maple, ash, and chestnut, is pure raw Italian sienna, tinted with pure white lead, not the so-called sienna which is sold by most paint dealers under that name, but the genuine article, which can be, and should be obtained even at some cost and trouble, the said article being one of the most useful and indispensable articles in the paint shop. For maple ground, of course the smallest quantity is required, it being necessary only to change the white to the faintest suggestion of straw color. For ash, the ground should be a little darker. For light oak, more of the sienna will be required, while for chestnut a decidedly yellowish tone is wanted. Care must be taken not to make the grounds too dark. Rather in the other extreme, for the reason that there is a remedy for a too light ground, in the application of a greater quantity of graining color, as also in the glazing coat; while a ground too dark cannot be made lighter. For dark oak, burnt Italian sienna with white will produce a far better ground than any other single color. The same caution must be observed, however, in obtaining this color as recommended in the case of the raw Italian sienna.
The domestic so-called siennas will not prove substitutes for the genuine Italian pigments. The ground for black walnut may be the same as for light oak with the addition of a little burnt sienna and black.
The primary colors are those that cannot be compounded from other colors, being pure in themselves; they are three in number-red, blue and yellow; and from these three all others are compounded. From each of the three primaries in combination with either of the others, is derived certain groups of colors, termed secondaries and tertiaries, with the variations of tints and shades. All of these are regularly classified, and their combinations may be learned according to rule, with great pleasure to the learner, and an almost limitless addition to his resources. A standard authority on these subjects is "Chevreul on Color," which may be obtained at any book store. The combinations named below will enable the painter to mix many colors that he may require.
 
Continue to: