This section is from the book "Furniture A Girl Can Make", by William W. Klenke. Also available from Amazon: Furniture A Girl Can Make.
A wastepaper container is indispensable in keeping order in your room. The model here shown is unusual in that a unique kind of covering has been specified.
You can make this project out of 1/4" plywood or wall board that is of paper construction, known as fibre board (no plaster boards). A good size for such a container will be about 12" square at the top and 14" high. The bottom piece should project a little beyond the sides to give a better effect to the model.
Step 1: Cut out the sides to the correct sizes and shape. Make a slight taper to each side.
Step No. 2: Securely glue and nail the corners together and then glue and nail the bottom in place. If fibre board is used, the corners must be glued together and reinforced by running a strip of heavy cloth up the inside of each joint.
Step No. 3: Sandpaper all surfaces smooth and true. Do all sandpapering by folding the sandpaper over a scrap block of wood so as to insure flat surfaces. The final rubbing is done by holding the sandpaper in the palm of your hand and slightly round all sharp corners. Before applying the finish, clean off all sawdust with a soft brush.
Now apply a thin coat of white shellac to the entire model. The shellac should be thinned with a good quality of alcohol.

Step No. 4: The covering material you will use, will depend upon what you have on hand or can easily procure. If you have enough "stickers" such as the porters place on your baggage when traveling, or a number of decorative small posters, or colorful illustrations from magazines, dinner menus etc., use them in this way. Glue the sticker, poster or pictures to the outside surfaces, fitting the pieces so as to have them appear to overlap in a pleasing manner; you will be gratified as to the results thus obtained. Before pasting these pieces of paper on the project, apply a thin coat of white shellac and allow to dry.
After you have pasted the posters etc., in place, allow this covering to dry at least five hours; then apply a thin coat of shellac. Allow this coat to dry and follow with a second coat of shellac; this is a little heavier coat.
Paint the inside of this project with at least two coats of paint, one flat and one of eggshell enamel, using some neutral color as a grey or soft grey green. It will be very effective to paint the top edge in black.
If the finish described above does not appeal to you, then simply paint the entire model inside and outside. It will be more attractive to paint the inside a different color from the outside. A very striking effect can be obtained by painting the inside a bright red and the entire outside in a black. Use enamel for the last coat.
 
Continue to: