Specification No. 30 - Painted Finish On New And Old Floors Not Previously Painted (Interior)

The surface shall first be cleaned and entirely free from grease and moisture. Three coats of Sherwin-Williams Inside Floor Paint shall then be applied, allowing forty-eight hours, or until perfectly dry, between each coat.

Specification No. 31 - Painted Finish On Old Floors Which Have Been Previously Painted (Interior)

The surface shall first be cleaned and entirely free from grease and moisture. Two coats of Sherwin-Williams Inside Floor Paint shall then be applied, allowing forty-eight hours, or until perfectly dry, between each coat. (All stencils applied with Flat-tone Glaze Colors.)

Specification No. 32 - For Unsightly Cracks And Seams In Floors

All cracks and seams shall be thoroughly cleaned out, and after applying the first liquid coat they shall be filled with Sherwin-Williams Crack and Seam Filler.

Specification No. 33 - Flat-Tone Finish On Rough Or Smooth Plastered Walls And Ceilings

All plastered walls in the following rooms shall be finished as follows: First apply a coat of Sherwin-Williams Flat-tone, color to be selected by owner or architect, thinned bulk for bulk with a mixture composed of equal parts raw linseed oil and pure spirits turpentine. Apply second coat of. Sherwin-Williams Flat-tone, thinned four parts Flat-tone with one part of liquid composed of equal parts pure spirits turpentine and pure raw linseed oil. Apply third or last coat of Sherwin-Williams Flat-tone, thinned two parts Flat-tone with one part pure spirits turpentine only.

Note

Sherwin-Williams Wall Varnish Size can be used instead of the first coat of Flat-tone, if desired.

Specification No. 34 - Flat-Tone System On Rough Or Smooth Plastered Walls And Ceilings

All rough or smooth plastered walls and relief parts in the following rooms shall first be finished as specified above for "Flat-tone Finish." After allowing this surface to dry thoroughly, a coat of Sherwin-Williams Flat-tone Glaze Color, in shades selected by owner or architect, shall be applied. Flat-tone Glaze Colors shall be reduced with Sherwin-Williams Flat-tone Glazing Liquid.

Specification No. 35 - Decotint Finish For Ceilings And Walls (Cold Water Paint)

The wall shall first be sized with a glue size or with Sherwin-Williams Special Wall Size. Mix Sherwin-Williams Decotint with cold water, using only enough water to make a heavy paste and stir thoroughly, until all lumps have disappeared before thinning down to proper brushing consistency. Then apply one or two coats with wide Kalsomine brush.

Specification No. 36 - Staining And Varnishing Woodwork At One Operation (Old Woodwork Or Furniture Previously Finished)

First apply a coat of Brighten-Up Stain Ground as it comes from the can. After forty-eight hours, or when thoroughly dry, a coat of Brighten-Up Stain, in shade selected, shall be applied.

Note : - A dull finish can be produced by applying one coat of Sherwin-Williams Velvet Finish Varnish after previous coats are thoroughly dry.