Place and line 2x4 plates around the outer edge of the building, then measure and locate all partitions, marking them on the plate and sub floor with a chalk line. Line all partitions on the sub floor to lay the partition plates. To space the outside studdings, begin at the front, measure 15" and 17" from the corner for the spacing of the first studding, then continue 16" from these markings, the studding will be 16" center.

For all partitions space first studding 15" and 17" from intersecting wall and continue spacing at intervals of 16" from these markings, the same as on the outside wall plates. This will locate studdings with 16" centers for lathing. Place the studding directly over the joists for bearing partitions where possible. Locate all door and window openings and mark them on the plate, then make a duplicate plate for the top, laid beside the bottom plate, and mark the same spacings as for the bottorn plate, and the studs will be parallel to each other. Double the top plate after the studs have been put in place and raised. Lap joints at the corners and partitions with the top plate. (Fig. 9.)

Fig. 9