Half Size.

Model No. 17. - Clothes Hanger.

For back piece prepare from a 7-8" board an oblong 13-16" x 3 9-16" x 16 1-16". Transfer plan drawing. Bore holes with auger bit. Cut around lines with tenon and turning-saws. Cut to lines with chisel, knife and file. Bevel edges with plane, knife and file. Finish surfaces with sand-paper, except under surface.

For pins prepare from a 7-8" board a piece 1" x 13'. Prepare from this three oblongs 25-32" x 25-32" x 4 1-16". Transfer plan drawing upon opposite sides of these. Cut around lines with hacksaw; cut to lines with chisel, knife, and file.

Finish with sand-paper excepting dowels. Fasten pins to back board with glue and wedges. Finish under surface with smoothing-plane when dry.