Fig. 35 shows the casting for a small engine crank, the pattern being shown in Fig. 36. The base A, which is semicircular at each end, is shaped from a board large enough to finish 1/2 in.

Small Engine Crank 271

Fig. 35. Small Engine Crank.

thick and 2 1/4 in. diameter at one end and tapering with a straight taper to the other end, which is 1 3/8 in. diameter. Do not finish quite to the lines until the collars have been fastened on, and be

Small Engine Crank 272

Peg and Tube, Plate and Shoulder Brass Dowels.

sure to mark the circles on the top or face side of the base. The two collars C and D, Fig. 36, are turned on a screw centre, the fillets B being turned preferably as a part of each collar, the necessary draft allowances being made at this time. The holes to receive the bottom core prints should be turned or bored out before the collars

Small Engine Crank 273

Fig. 36. Pattern for Engine Crank.

are removed from the lathe, care being taken not to strike the screw. The collar C is so thin that it may be found necessary to cut in with the sharpened end of the tang of a file in order not to cut into the screw. The collars are to be glued and nailed to the base, after which the fillet on the outside half of each collar is to be removed carefully with a sharp chisel, care being taken not to work against the grain. The edges of the base should now be worked down to the line, making a straight taper sufficient for draft, the parting line between cope and no well coming at the top surface of the base.

The centre marks, which were made upon the top or face side of the base, are the centres of the holes which are to be bored to receive the ends of the core prints, which must and will come directly over the bottom core prints if directions

Small Engine Crank 274

Figs. 37 and 37A. Core Prints for Engine Crank.

given here have been carefully followed. The top and bottom parts of the core prints should be glued at the same time and clamped tightly in place with an iron clamp or in a vise. The two core prints are shown in Fig. 37 and are turned from pieces of clear dry pine of a size sufficient to easily finish to the required dimensions.

Half core boxes are to be used, care being taken that the half circles are exactly the right size. As these are to be made in the same manner as the core box for the gland previously described, no further directions should be necessary.

The surfaces requiring finish are marked "'f" as in previous patterns, and the necessary allowance for finish and for shrinkage and draft should be figured out before the pattern is commenced.

In the next article I shall describe the making of split patterns. These split patterns are, of course, dowelled, wood dowels being used for ordinary small patterns. Brass dowels are unquestionably far superior to wood dowels and are much used for fine accurate work, their superiority lying in the fact that they are always perfect fitting and interchangeable. The brass dowels can be bought from 1/8 in. up to 5/16 in. in diameter. For large work brass plate dowels are very largely used, running from 2 in. to 2 1/2 in. in diameter. Through the courtesy of the Winkley Co., Hart-ford, Conn., and Timmens & Chissold, Bound Brook, N. J., I am able to show you the accompanying illustrations of peg and tube brass dowels, plate brass dowels and shoulder brass dowels.