Specification No. 20 - White Enamel Finish On Cement Or Plaster (High Gloss)

All cement or plaster walls, wainscotings, or other parts designated in the following rooms shall be finished as follows: Three or more coats, as may be necessary, of Sherwin-Williams Flat-tone "White" shall be applied to produce a perfect surface and foundation for following coats of Sherwin-Williams Enamelastic. Allow sufficient time for thorough drying between coats of Flat-tone, and sand each coat with oo sandpaper, avoiding all brush marks. After this surface has been approved by architect or owner, apply one coat of Sherwin-Williams Enamelastic Interior.

Specification No. 21 - Natural Finish For Floors Of Oak And All Open-Grain Woods

All oak (or other open-grain wood) floors in the following rooms shall be finished as follows: First the wood shall be filled with Sherwin-Williams Transparent Paste Filler; when thoroughly dry, sand down smooth with oo sandpaper, after which apply three coats of Sherwin-Williams Mar-not, first coat of which shall be thinned 10 per cent. and second coat 5 per cent. with pure spirits turpentine, and third coat to be applied as it comes from the can, allowing sufficient time between coats to thoroughly dry before applying the succeeding coats. Each coat of Mar-not, except the last, shall be sanded with 00 sandpaper. (For a dull finish the last coat shall be rubbed with pumice-stone and oil.)

Specification No. 22 - Natural Finish For Floors Of Hard Pine And All Close-Grain Wood

All hard pine (or other close-grain wood) floors in the following rooms shall be finished as follows: Three coats of Sherwin-Williams Mar-not shall be applied, thinning first coat 10 per cent. and second coat 5 per cent. with pure spirits turpentine, and applying the third coat as it comes from the can, allowing sufficient time between coats for thorough drying. All coats of varnish, except the last, shall be sanded to a good surface with 00 sandpaper. (For a dull finish the last coat shall be rubbed with pumice-stone and oil.)

Specification No. 23 - Stained And Wax Finish On Floors Of Pine Or Other Close-Grain Wood

All floors in the following rooms shall be finished as follows: First, the bare wood shall receive one coat of Sherwin-Williams Handcraft Stain, color to be selected by owner or architect, and allowed to dry over night.

Then apply one coat of Sherwin-Williams Mission-lac, allow time to dry thoroughly, sandpaper to a smooth, dull surface, and apply Sherwin-Williams Floor Wax with a soft cloth. Rub off all surplus wax, bringing work to a wax polish.

Specification No. 24 - Stained And Wax Finish For Floors Of Oak Or Other Open-Grain Wood

All floors in the following rooms shall be finished as follows: First, the bare wood shall receive one coat of Sherwin-Williams Handcraft Stain, color to be selected by owner or architect, and allow to dry over night. One coat of Sherwin-Williams Paste Filler, color to be selected by owner or architect, shall then be applied, and before it is set hard wiped off across the grain with burlap or excelsior. Then apply one coat of Sherwin-Williams Mission-lac, allow time to dry thoroughly, sandpaper to a smooth, dull surface, and apply Sherwin-Williams Floor Wax with a soft cloth. Rub off all surplus wax, bringing work to a wax polish.