This joint shown in Fig. 537 is a common, simple, and good way of joining two sticks when they cross at right angles or obliquely. Place the sticks in position and mark the width of each upon the surface of the other, using a knife or chisel for wood between (Fig. 538). With large pieces the lines should be marked by the square, the depth (one-half the thickness of either scribing. With small sticks the wood can be removed with the knife, first cutting a notch at each side and then paring off the piece) by the gauge. The lines at the outside of the space can then be sawed down to the gauge line, taking care to keep just on the inside edge of the line. The wood between can be pared out with the chisel down to the gauge lines. When the halving is at the ends of the pieces or at the end of one piece (Fig. 539), the process is the same, except that the wood can be entirely removed by the saw. Other forms involving bevelling and dovetailing are shown in Figs. 540, 541, and 542. This principle of the lap joint is often carried a little further and we have the open mortise and tenon (Fig. 543), which can successfully be applied to a mitred joint and can also be dovetailed, and boxes are now made by machine with the corners entirely made up of a continuous series of these joints (Fig. 544). See Joints.

Fig. 537.

Fig. 538.

Fig. 541.

Fig. 542.

Fig. 539. Fig. 540.

Fig. 543.

Fig. 544.